• The need to simplify the diagnostic methods utilizing DNA isolation along with cost reduction.

• Simple DNA purification methods may serve the matrix specific approaches and automatization.

• Comparative study on DNA purification methods from microbial cells.

• Innovative simplification of diagnostic methods is beneficial regarding time and expenses.

Identification of pathogenic microorganisms using classical cultivation methods is often time-consuming and gives inadequate results that have to be verified via further and sometimes long-lasting cultivation steps [1] [2]. Based on historical reasons and the relatively cheap component prices, this is still at practice in most laboratories, especially those connected to agriculture and animal or human healthcare. In past decades, the development of molecular biological methods and the continuously broadening bioinformatic background promoted the emergence of improved microbe detection methods [1] [3]. The widely available nucleic acid amplification-based detection and identification methods coupled with foregoing cost-effective and rapid DNA isolation protocols allow the completion of the entire diagnostic procedure within a day or even in several hours [4] - [10]. Microbe detection may also rely on microbe-related proteomic characteristics or microbe-specific immune responses. In addition to the widely used and accepted ELISA techniques, many other instrument-dependent solutions are accessible recently [11]. Among others, the wide distribution of mass spectrometry techniques and the continuously broadening, supporting databases supply the opportunity of extremely sensitive and fast microbe detection, although their standardization is quite labor-intensive and often matrix-specific [12] [13] [14]. Among recently published papers, there are several results using Bio-layer interferometry to detect and identify microbes out of different sources but it is facing the same difficulties as mentioned above [15] [16]. The unrelenting need for rapid and reliable methods in the diagnostics of pathogens and indicator microorganisms have always existed, because the quickly achieved results reduce economical losses, shorten the action/reaction time along with protecting animal and human health and the market value of distinct products due to the opportunity for early intervention [17] [18]. Drinking water, being the most important and indispensable product of food industry produced in enormous volumes is of high priority to be free of pathogens.

Regarding sample handling, following or instead of microbe enrichment, one strategy of quick and economical nucleic acid purification is simply to lyse the cells by heating under hypo-osmotic circumstances with simultaneous depletion of PCR inhibitors using Chelate exchange resin, e.g. Chelex-100. This method is quite user-friendly due to the limited number of pipetting steps and, in addition, it gives considerably good qPCR results [4] - [9]. Other potential way is to lyse microbes in ethanol containing denaturing alkaline solution (EtNa—Ethanol and NaOH) to directly precipitate the deliberated DNA and separate by centrifugation. At the same time, soluble, undesired materials having inhibitory effect on PCR reaction are washed away, providing relatively pure DNA with only several pipetting steps within half an hour [10]. These alternatives are suitable substituents of commercial silica-based methods with comparable results, shorter or equal processing times, less pipetting steps beside their meaningful financial benefit. Here, we report the evaluation of these methods supplemented with slight modifications in microbial DNA purification from physiological salt solution or water inoculated with microbial colony compared to a widely used commercial kit. The osmotic stress caused by pure water facilitates the lysis of microbes and as a consequence, result in even more efficient DNA purification and better DNA yields. The results presented here aim to encourage the use of simple, earlier described methods as a point of origin in diagnostic developments and promote simplification of methods giving satisfying results even in matrix-specific situations. As model organisms for demonstrative purposes, we examined two Gram-positive (Listeria monocytogenes, Staphylococcus aureus) and two Gram-negative (Escherichia coli and Salmonella enterica) pathogenic species which are important in food safety being very common indicator strains, and a yeast Zygosaccharomyces bailii that can cause food spoilage and thereby economic damages [19] - [24].

The need for shortening microbe detection and either to supplement or to substitute classical cultivation methods with novel molecular biological approaches in food industry or any other agricultural field is obvious. Due to multiple steps of microbe cultivation, the classical methods may be time-consuming and often yield uncertain results with a consequence of further verification steps [25]. In addition, the sensitivity of most economical molecular methods may be rarely satisfying [3] [17] [30]. We focused our interest on aqueous solution (saline) as inoculation model for drinking water, as the most frequent food product. Applying saline solution prevents spontaneous osmotic stress of microbes preserving their viability longer opposed to water matrix that makes microbes more susceptible to applied lysis treatments [31]. We used two Gram-negative as well as two Gram-positive bacterial strains along with one yeast species as model organisms to demonstrate the potential and efficiency of the chosen methods. At each method the effectiveness of DNA purification was evaluated regarding to the microorganism tested. Furthermore, we compared the earlier published methods and their slightly modified counterparts regarding their lysis efficiency, PCR compatibility, price, simplicity and the time needed for completion. One of the approaches is based on heat-driven lysis of microorganisms and parallel binding of PCR inhibitors using a chelate exchange resin, such as Chelex-100 [4] [6] [8]. In such case, the purity of the DNA is not a main goal, though the qPCR compatibility may be taken into account when analyzing the amplification curves. Even though the Chelex-based methods do not yield pure DNA, and not only proteins, but also other substances might be present in the supernatant, it is important to emphasize that the qPCR inhibitors can be satisfactorily depleted. In certain cases of complex matrices, however, the effectivity of inhibitor depletion has to be experimentally determined as residual organic and some other compounds may substantially impair the polymerase-assisted amplification of desired sequences [32]. Another user-friendly DNA purification method used applies alkaline lysis and ethanol precipitation of the sample DNA [10]. Compared to a commercial kit we managed to ascertain that the used alternative methods may give comparable, or in certain cases, even better Cq values. Under given circumstances, the Gram-negative bacteria were more effectively lysed and amplified using Chelex-100-based methods, which gave better results than the commercial kit. In addition, Chelex-based methods are 10 times more cost-effective and need incomparably less time to carry out the whole procedure from bacterial sample to PCR-ready DNA. In case of Gram-positive bacteria, the Chelex-related approaches were still satisfying, although EtNa-based DNA purifications were a bit more effective in a species-dependent manner, with worse reproducibility. Later on, this could be improved using silica columns as suggested in the original paper of Vingataramin and Frost (2015) instead of pelleting the DNA by centrifugation resulting in a slight but still acceptable elevation of cost per sample [10]. The lysis and amplification of Zygosaccharomyces cells seemed to be a bit more efficient using EtNa solution for lysis compared to protocols using Chelate exchange beads. After the comprehensive description we summarize the edification of our results on the used DNA purification techniques according to several interesting aspects.

Results in the case of Gram-negative bacteria: The relatively thin cell wall compared to Gram-positives makes this group of bacteria more sensitive to heat and chemical lysis [31]. According to our results, this characteristic was obviously confirmed because compared to the reference method Cq values of Gram-negatives were lower than in case of Gram-positives. We experienced better Cq values after lysis on 100˚C by chelate-exchange resin-based inhibitor depletion than with any other method including the commercial kit as well. Interestingly, the standard deviation between biological replicates was also significantly lower in this group. The chosen, economically relevant bacteria: Salmonella enterica and Escherichia coli behaved similarly in different protocols. Results are summarized in Table 4 and illustrated in Figure 1.

Results in the case of Gram-positive bacteria: In case of Listeria monocytogenes and Staphylococcus aureus the results of purification processes were not that coherent as seen in case of Gram-negatives. Listeria seemed to be more susceptible to alkaline lysis than to simple heat in contrast to S. aureus that showed better Cq values when lysed by heat. Regarding reproducibility this group was more stochastic in our hands, but generally alkaline lysis and ethanol precipitation seemed to be more reliable when using a silica column, which makes the method more expensive. Within this group, the Gram-positive method recommended by the manufacturer of the used commercial kit was proven to be the most effective way of DNA purification, although as seen in Table 4 and Figure 1, the more economical solutions might also be satisfying in most cases.

Results in case of a yeast species: Although the lysis of yeasts with not exclusively oversimplified methods might be challenging, the Chelex-based approaches and the method presented by Vingataramin and Frost (2015) resulted in excellent Cq values compared to the used commercial kit which is in concordance with observations presented earlier [10]. Regarding the reproducibility of all the methods, elevated standard deviations were observed, except for the GeneJET, which was highly reproducible but lagged behind slightly with the Cq value indicating lower DNA yields. Cq values and standard deviations are summarized in Table 4 and Figure 1.

EtNa vs. EtNa-Chelex: In certain cases the supplementation of DNA dissolving buffer with chelate exchange beads may improve yield or purity of DNA in case of e.g. E. coli, S. aureus, L. monocytogenes or Z. bailii, although the real importance of Chelex-100 in resuspension solution seemed not to be very meaningful, indicating, that the precipitation and the centrifugation steps remove PCR inhibitors sufficiently.

Direct vs. indirect methods: In general, when inoculating colonies into saline or when using culture medium solution directly for DNA purification (unpublished data), there seems to be no need for discarding the solution before

−ΔCq ave means Cq differences between the average of replicates of the given method and the reference GeneJET kit. Positive values mean better results, namely lower Cq value with the indicated method. In case of −ΔCq ave column, the best 2 - 3 is highlighted in grey. Best sd values below 0.3 are also in grey, while worst ones with sd value above 0.6 are framed. Abbreviations: Ch.: Chelex, cf: centrifuge, C.: Column.

addition of the lysis buffer, and can be used directly giving the same yield and amplification curve in the subsequent qPCR reactions. The best way of isolating the DNA from cultured microbes is to directly inoculate the lysis solution and go for heating. In this way, the pipetting steps may be reduced to only one (pipetting the lysis solution into empty Eppendorf tube before inoculation) at least in the case of the direct Chelex-100 method. As the EtNa method requires the disposal of the supernatant after DNA precipitation and centrifugation and the subsequent pipetting of DNA resuspension solution results in additional two pipetting steps compared to direct Chelex-100.

Time of completion: The fastest method is direct Chelex. According to our experiences for Gram-negative bacteria a two-minutes-long lysis with continuous shaking at 100˚C is efficient enough (unpublished data) and the time required to get to the qPCR-ready DNA from a colony is less than five minutes (two minutes 100˚C, one minute centrifugation and some handling time). The heat-driven hypo-osmotic lysis of Gram-positive bacteria and yeasts needs to be longer but applying 10 minutes of boiling still allows user to complete the process within a quarter of hour.

Price of DNA isolation out of one sample: EtNa-based methods are undoubtedly the cheapest solutions for DNA isolation regarding only the chemical treatment except for the situation when applying silica column in place of the classical DNA precipitation step with high-speed centrifugation. When considering consumables, e.g. pipette tips and Eppendorf tubes, direct Chelex turns to be preferable from economical point of view (see Table 5). The relative price of GeneJET for one sample was calculated for Gram-negative bacteria. For Gram-positive and fungi the prices are higher because of special lysis buffer containing Lysozyme and Zymolase, respectively.

Effectiveness: In certain experiments with Gram-positive bacteria and Zygosaccharomyces EtNa was experienced to be slightly more effective than Chelex-100 or the used commercial kit, although in our hand, the reproducibility of EtNa methods was not really satisfying because the Cq values showed high standard deviation (sd) as compared to other methods, which could be significantly improved by applying silica columns instead of high speed centrifugation similarly to the results of Vingataramin and Frost (2015).

As presented above, beside the Cq value and the reproducibility, the completion time, the number of pipetting steps and the price of a single reaction has also been considered, because molecular biological effectivity is only one side of the coin. The calculated data, regarding previously mentioned parameters, are presented in Table 5. Naturally, the exact numbers in Table 5 may vary individually depending on the source of the materials used including consumables and chemicals, although the relative cost ratios would not change dramatically. According to these results in the case of simple matrixes such as water, PBS, saline solution, culture medium or directly the lysis solution inoculated with the given colony there is no need to pellet the microbes prior to lysis. The direct methods yield equally satisfying results, though depending on the species, some fluctuation in Cq values might occur. No doubt, the Chelex-100 based methods were outstanding from the economical (cost, time and handling) point of view.

Taken together, several cheap, short and excellent recipes are available for microbial DNA isolation from physiological salt solution, colonies or bacterial culture media. Besides the well-formulated commercial kits, the PCR-ready DNA

The relative price of GeneJET for one sample was calculated for Gram-negative bacteria. In the case of Gram-positives and fungi the prices are higher because of special lysis buffer containing Lysozyme and Zymolase, respectively. As currency and other circumstances have an effect on the prices of the components, the cheapest method, Direct-Chelex was regarded as 1 unit and others are shown in proportion accordingly. The Pipetting steps column include the handling of sample as the first pipetting. Abbreviations: Ch.: Chelex, cf: centrifuge, C.: Column.

can be easily purified with these alternative methods within much less than 20 minutes. While avoiding compromises concerning the DNA yield when using the above mentioned approaches, both the prize and duration time of DNA preparation can be minimized. Last but not least—due to lower consumption of plastic material as well as harmful solutions—the carbon footprint of these procedures is significantly lower. It is difficult to claim one of the above described experimentally analyzed methods for the best approach at any situation but for general purposes using simple matrixes, the direct Chelex method is undoubtedly a good option to obtain purified DNA for PCR and/or qPCR amplification. When the starting material is more complex, additional matrix-dependent treatments may be required prior to DNA purification. Nevertheless, the simple methods mentioned here are good starting points for the development of matrix-specific or more general cost-effective DNA purification procedures aiming the detection of pathogenic or indicative microbes from any sample. In addition to these considerations, the simple methods consisting of only several pipetting steps have a good potential for adopting automatic procedures and robotic handling providing high throughput sample processing if required [33].

No conflict of interest declared.

Bánkuti, B., Tudós, Z., Szathmary, S., Stipkovits, L., Sipos-Kozma, Z., Ásványi, B., Józsa, Á., Rajčáni, J., Szenthe, K. and Bánáti, F. (2020) Comparison of Economically Favourable and Further Development Friendly DNA Isolation Methods from Microbial Cultures. Advances in Microbiology, 10, 1-13. https://doi.org/10.4236/aim.2020.101001