The study area stresses across six Local Government councils in the southern part of Ondo and Ogun States, South Western Nigeria. It is bounded by the following coordinates: longitudes 4˚22'22.5''E and 5˚10'2.0''E and latitudes 5˚50'44.1''N and 6˚39'39.5''N and it covers a total area of about 4200 km² (Figure 1). The area is generally characterized by flat and gently undulating topography. The elevations vary between 13 to 83 m above sea level in the mainland and 2 to 10 m in the coastal area (Figure 2).

The study area is underlain by the sedimentary sequence of the Dahomey basin. The Dahomey Basin stretches from south-eastern Ghana to south-western Nigeria. It is separated from the Niger Delta by the subsurface basement high (Okitipupa Ridge) around Okitipupa in Ondo State, Nigeria [18] [19] . Dahomey basin contains extensive wedge of Cretaceous to recent sediments, which thicken towards the offshore [20] (Figure 3). Six lithostratigraphic units have been identified by various workers. The formations from the oldest to the youngest includes: Abeokuta Group (Cretaceous), Ewekoro Formation (Paleocene), Akinbo Formation (Paleocene-Eocene), Oshosun Formation (Eocene), Ilaro Formation (Eocene) and Benin Formation (Oligocene-recent). The known aquifers in the study area are mostly within the Benin Formation [21] . The formation consists of unconsolidated, poorly sorted sands with lenses of clayey shale [22] .

Figure 5 shows the geoelectric section connecting Ajegunle, Igbinsin-Oloto, Orereara, Ileriayo, Oriopo, Apata Ijaw, Molutehin and Oretan along the northwest-southeast direction. Three to seven geoelectric layers were delineated across

this section, which corresponds to four geologic layers; the topsoil (red sand), coastal alluvium (white sand), lateritic sand, clayey sand/mud-peat and sandy clay. This section reveals possible presence of brackish/saline water in Ileriayo, Oriopo, Apata-Ijaw and Oretan. This suspicion is based on the low resistivity values (below 60 ohm-m) obtained within the coastal alluvium and clayey sand beneath these VES locations.

Figure 6 shows the geoelectric section connecting Atijere, Obe-Rebiminu, Zion, Temidire, Abaalala, Gbabijo, Asisa, Eruna, Ayetoro, Obenla, Awoye, Molutehin and Oretan along the southwest-southeast direction. Four to five geo-

electric layers were delineated across this section which corresponds to three geologic layers; coastal alluvium, clayey sand/mud-peat and sandy clay. Low resistivity values (mostly below 30 ohm-m) were delineated within coastal alluvium and clayey sand beneath Obe-Rebiminu, Zion, Gbabijo, Asisa, Abaalala, Eruna, Ayetoro, Obenla, Awoye, Molutehin and Oretan. These low resistivity values are indicative of brackish/saline water. The proximity of these locations to the Atlantic Ocean is responsible for this saline intrusion.

The north-south geoelectric section (Figure 7) connecting Ominla, Oluagbo, Igodan Lisa 2, Igbokoda 2, Oriopo, Ugbo, Ugbonla and Ayetoro delineated very low resistivity values beneath Idepe, Ugbo, Ugbonla, Adagbakuja and Ayetoro. Four to six geoelectric layers were delineated across this sections and they corresponds to five geologic layers namely; topsoil (red sand) which gradually change to coastal alluvium towards the shore line, lateritic sand, sandy clay/ mud-peat and clayey sand. Low resistivities (1 - 60 ohm) typical of saline water intruded layer were delineated beneath Ugbo, Ugbonla and Ayetoro. Resistivities of all the layers delineated along this section decreases toward the shore, this suggest that the saline water intrusion mapped along this geoelectric section emanated from the Atlantic Ocean.

The second north-south geoelectric section (Figure 8) connects Loda, Ayadi, Legbogbo, Irele Road, Omi, Igbotu, Adagbakuja, Apata Ijaw and Awoye. Low resistive layers were delineated beneath Legbogbo, Irele road and Omi area. However the IPS results (Table 2) showed that low resistivities recorded in these areas are due to presence of clay layers beneath these VES locations. Towards the coast at Adagbakuja, Apata Ijaw and Awoye low resistivity values (1 - 3 ohm-m) were recorded, indicating possible presence saline water within the coastal alluvium, sandy clay/mud-peat and clayey sand layers.

The aquifer layers across the study area were identified and presented as resistivity and depth maps.

The resistivity of the first aquifer layer (Figure 9) varies from 0.2 (Obenla) to 1569 ohm-m (Ayadi). In the coastal areas and Agbabu, Ilubirin and part of Ode Aye in the northern part of the study area, the resistivity values fall below 60 ohm-m, suggesting that the shallow aquifers in these locations might contain brackish or saline water. The IP sounding results (Table 2) give low chargeability values within the low resistive layer at Agbabu, but high value at Ode Aye, thereby confirming possible saline water intrusion only in Agbabu. That saline water exists in Agbabu was equally attested to by hydrochemical analysis earlier carried out across the study area [11] [24] . The depth to first aquifer layer ranges from 0.7 (Eruna and Molutehin) to 151.5 m (Itebukunmi). The depth to first aquifer layer map ((Figure 10) shows that depth to first aquifer layer is generally shallow (less than 5 m) in the coastal area and generally water logged. The first aquifer unit in this area is highly susceptible to anthropogenic pollutants due to its shallow nature and possible poor protection by the overlying sandy layers.

The resistivity of the second aquifer layer (Figure 11) varies from 0.5 (Molutehin) to 904 ohm-m (Apata Ijaw). The low resistivity values along this aquifer extends only to some coastal towns, such as Obe-Rebiminu, Eruna, Ugbo, Gbabijo, Adagbakuja, Abealala, Awoye, Ugbonla, Araromi seaside, Ayetoro, Molutehin and Oretan. It also extends to the north eastern area of Owode, Iyansan, Agadagba, Laworo, Legbogbo, Lokaka, and Irele and including Ode Aye, Oluagbo, Okitipupa and Idepe in the north central part of the area. The IP sounding results (Table 2) again shows high chargeability values at Odeaye, Iyansan road and Agadagba thereby eliminating the possibility of saline water within the second aquifer layer within the northeastern area. The depth to second aquifer across the study area varies from 1.4 (Awoye) to 305.5 m (Owode

road). The map showing depth to second aquifer layer (Figure 12) indicates that depth to this aquifer layer is shallow (less than 23 m) in some part of the coastal areas, such as Obe-Rebiminu, Araromi Seaside, Temidire, Ugbonla, Ayetoro, Awoye, Molutehin and Oretan. Likewise in some places in the mainland the intermediate aquifer also exists at shallower depths. Some of these areas are closer to streams and river tributaries which are directly or indirectly connected to the sea water. This explains the possible brackish/saline water suspected in these areas.

The resistivity of the third aquifer unit (Figure 13) varies from 0.4 (Eruna) to 665 ohm-m (Oriopo). The low resistivity values along this layer extends to Araromi seaside, Obinehin, Gbabijo, Adagbakuja, Ugbonla, Eruna, Ayetoro, Awoye and Molutehin in the coastal area. This is indicative of saline water intrusion in this area. However in the northeastern part of the mainland, low resistivity val-

ues were delineated in many places such as: Ayadi, Legbogbo, Irele road, Lokaka, Laworo, Agadagba, Arogbo and Amapere. This probably suggests that aquifers in this area contain brackish to saline water. Again the IP sounding results nullified any suspicion of occurrence of brackish/saline water intrusion in these areas, based on high chargeability values obtained from these area.

The depth to the third aquifer layer (Figure 14) ranges from 12.9 (Awoye) to 452.9 m (Arogbo). The depth to the third aquifer layer is generally significant (about 100 m) in most parts of the coastal towns and mainland with the exceptions of Zion, Temidire, Ogoluwayo, Ebute Ipare and Abealala, in the western and eastern parts of the study area.

Average longitudinal resistivity; a second order geoelectric parameter was calculated from the primary geoelectric parameters and presented as map (Figure 15). The map enabled the delineation of lateral extent of saline water intrusion across the study area based on resistivity values. Low resistivity values (less than 60 ohm-m) were considered to be brackish to saline water intruded zone.

Saline map showing the extent of saline water into areas (Figure 16) was generated based on the three aquifer layer maps and the average longitudinal resistivity map. The map project possible extents of saline water intrusion across the study area. The map shows that the southeastern part are the largely affected by saline water intrusion, this perhaps due to the fact that there are more tributaries in this area through which sea water can move land ward.

Strong correlation was also observed between the depth to the saline water in a given location and the distance from salinity source; Ocean, tributaries, canals, streams or rivers bearing saline water (Figure 17). Where a location is close to the source of saline water, the depth to the saline water will be shallow and conversely where the location is far from salinity source depth to the saline water will be deeper. The correlation curve (Figure 17) shows a strong direct correlation (r² = 0.8564) between distance of location from the saline water source and

depth to saline water. This can therefore serve as a predictive model to determine depth to saline water at any location within the saline water zone in the study area.