Supine upper thoracic on mid-thoracic spine thrust manipulation in cervico- thoracic flexion. The therapist uses the manipulative hand to stabilize the inferior vertebra of the motion segment targeted and uses the body to push down through the patient’s arms, to perform a high-velocity, low-amplitude thrust [5] [7] (Figure 2).

The therapist places the upper chest at the level of the patient’s middle thoracic spine and grasps the patient’s elbows. A high-velocity distraction thrust is performed in an upward direction [5] [7] (Figure 3).

The therapist uses the manipulative (left) hand to localize the motion segment targeted and uses both hands to perform a high-velocity, low-amplitude thrust into rotation, which was directed up towards the patient’s contra-lateral eye [5] [7] [8] (Figure 4).

One hand of the therapist stabilizes the skin of the patient and the other hand performs a longitudinal stoker over the TrP taut band [9] [10] (Figure 5).

The patients’ forearm is supinated at the point of hypo-mobility. The pad of the thumb is placed posteriorly against the radial head. The technique consists of applying a posterior-anterior glide of the radial head [9] [10] (Figure 6).

One hand of the therapist is used to glide the proximal forearm laterally, while the other hand fixed the distal end of the humerus while the patient performed a pain free gripping action. Ten repetitions are performed with an approximate 15-second rest interval between repetitions [7] [10] (Figure 7).

The therapist places his thumbs on the region of the carpal tunnel and flexes the index fingers over the back of the wrist forming a clamp. Holding the patient’s wrist, the therapist applies a three-dimensional traction while slightly extending the wrist [9] [10] (Figure 8).

(Left) shoulder girdle depression, gleno-humeral abduction and lateral rotation, supination of the forearm, elbow flexion and wrist, thumb, and finger extension; (right) shoulder girdle depression, gleno-humeral abduction and lateral rotation, supination of the forearm, elbow extension and wrist, thumb, and finger flexion [11] [12] (Figure 9).

(Right HVLA-Sacroiliac Joint): with the patient in the lateral decubitus position, if one side is more painful than the other it is positioned at the top (e.g. painful left side). The osteopath is positioned in front of the patient and searches the area of transition between the iliac and the sacrum: The leg is flexed until it sets the vertebral segment dysfunction in motion, with a rest in the popliteal fossa of the opposite leg, which is extended. Subsequently, the therapist holds the patient from the lower part of the shoulder, and brings the left side of the trunk in flexion and left rotation, until the movement arrives at the dysfunctional vertebral segment. The patient’s arms are positioned around the left arm of the osteopath. Following this, the patient is rolled towards the osteopath. Finally, the right arm of the osteopath applies a HVLA thrust to the pelvis in an anterior direction [5] [13] [14] (Figure 10).

(Patient Side lying, painful or treatment side up). Flex the top leg until you first begin to palpate motion at segmental interspace; place the patient’s foot in the popliteal fossa as shown. Grasp the patient’s bottom arm and shoulder and induce side bending and rotation until you begin to palpate motion at the segmental interspace. Have patient cross their arms by holding their own elbows. Reach through patient’s arms. Gently grasp patient’s side using broad hand contact and rotate the thorax backward.

Execution of the maneuver: While maintaining your setup log roll the patient towards you. Use your lower forearm and body to rotate the pelvis in opposite direction, Use your body to take up the slack and induce a HVLA thrust in anterior direction [5] [8] (Figure 11).

Patient supine towards the edge of the plinth, hip flexed to 90˚, knee allowed to fully flex to comfort.

Execution of the maneuver: Flex the hip into resistance up to 90˚, hold the thigh against your body. position mobilization belt pad in patient’s hip crease; strap belt around your hips. Apply graded caudal mobilizations by using a rocking motion with your body. Adjust the amount of hip flexion, rotation, and adduction. Apply large-amplitude oscillations out of resistance (grade II) or into resistance (grade III), or small amplitude into resistance (grade IV). A sustained caudal glide while passively applying pain free flexion and/or internal rotation [5] [15] (Figure 12).

Patient Prone, with hip resting in various degrees of flexion, abduction and external rotation.

Execution of the maneuver: Place both hands over posterior proximal femur, distal to hip joint. Position yourself directly over hip, elbows .localize the stretch the anterior capsule. Use your body to apply graded mobilizations to the hip joint. Direction of force is posterior to anterior with a slight medial inclination. Vary the direction of force based on stiffness and patient response. Apply large- amplitude oscillations out of resistance (grade II) or into resistance (grade III), or small amplitude into resistance (grade IV), [5] [15] [16] [17] (Figure 13).

(Longitudinal Mobilization/Manipulation (HVLA) at the hip): Patient Supine, both legs resting on the plinth.

Execution of the maneuver: Stand on the ipsilateral side at the foot of the plinth, with both hands, grasp patient’s distal tibia, just proximal to the malleoli, lift the leg into about 30˚ hip flexion, slight abduction and slight external rotation, the knee fully in extension. Apply a long axis distraction force by completely extending your elbows and leaning back with your body weight. Using your body weight distract to resistance and watch for the pelvis to drop with each weight shift. You can add varying amounts of hip Internal rotation/external rotation, or adduction/abduction to achieve the desired effect of mobilization. When desired motion and tension achieved, you may either apply graded long axis mobilization, or a high velocity low amplitude thrust in a long axis direction [5] [15] [18] (Figure 14).

Patient Supine with knee flexed.

Execution of the maneuver: Proximal hand: Grasp the posterior proximal tibia just medial to fibular head. Move soft tissue laterally until 2nd metacarpal phalangeal joint is against posterior fibular head. Distal hand: Serves as the movement hand by grasping the distal tibia. Rotate the tibia into external rotation with your movement. Engage barrier in knee flexion and apply Grade V mobilization (HVLA) into flexion direction [4] [5] [7] (Figure 15).

Supine, knee extended, foot slight off edge of table. Execution of the maneuver: Stabilizing hand grasps distal posterior tibia and rests it on the table. Mobilization hand uses either the thenar or hypothenar eminence on the anterior lateral malleolus,. Mobilize with an posteriorly directed force on the lateral malleolus [4] [5] [7] (Figure 16).

Patient Supine, foot off the edge of the table.

Execution of the maneuver: Grasp the patient’s foot with both hands. Small or ring fingers lie just below the neck of the talus. Both thumbs provide firm pressure to the mid forefoot. Engage restrictive barrier with ankle dorsiflexion eversion, slight pronation and distraction. Bring the ankle eversion and flexion forefoot to restrictive barrier. Apply a HVLA thrust in a caudal direction [4] [5] [7] (Figure 17).

Execution of the maneuver: The osteopath’s hands are placed at the level of the middle and lower thoracic structures, with the fingers along the costal arch. The structure is treated as though it were a cylinder, the hands testing the preference of this cylinder to rotate to the left and right along its central axis. Once the direction of greater rotational limitation has been established, the same assessment is made regarding the left and right lateral flexion. Once the two positions of restriction have been established, they are combined together and maintained. At this point the patient is asked to breathe in and hold their breath, and a Valsalva maneuver is performed for 3 - 4 seconds., then repeated for 3 - 4 breaths [6] [19] [20] (Figure 18).

Execution of the maneuver The thumbs or piriformis are positioned gently in the transverse direction on the projection of the mesenteric root, transversely to the centre of the line between the navel and the anterior superior iliac spine (ASIS). A thrust is applied to the visceral package, towards the pubic symphysis, so as to expect a counterthrust in return.

This is to be repeated a number of times, as if playing with the string of a bow, in order to redirect the tensions of the tissue. This can be aided by the respiratory cycle [6] [21] [22] (Figure 19).

Execution of the maneuver: The patient is in a supine position with their legs off the bed, with the leg not being treated fully flexed at the hip and knee. The osteopath stands opposite the side to be treated, and the patient’s foot on the same side as the flexed hip is brought against the side wall of the osteopath’s abdomen. One of the osteopath’s hands moves to the upper part of the knee and makes a slight downward thrust to extend the hip, while the other hand is at the level of the ASIS to incorporate the MB movement. Once the MB has been found the patient is asked to flex their hip in counter resistance for 7 - 10 seconds. After the isometric contraction, when the patient exhales, the hip is extended (towards the floor), to attempt a new MB, entirely painlessly, and the position is maintained for 30 seconds. The maneuver is repeated 3/4 times in order to obtain an additional gain for each iteration [6] [7] [23] (Figure 20).

Execution of the maneuver: Bring the pelvis toward the osteopath, performing a side-bending of the lower part of the patient with the limbs and trunk away from the osteopath. Thread the upper arm through the patient’s arms, which are located behind the neck. Make contact with the contralateral front part of ASIS of the patient (side of the treatment) with the other hand. The other hand holds the top of the shoulder and the shoulder blade. This increases the rotation of the patient’s trunk while maintaining the side in side banding. When performing this positioning, allow the ASIS to rise a few inches from the bed. The corrective action consists in performing a HVLA thrust with the hand resting on the ASIS, in a low behind direction [5] [6] [22] [24] (Figure 21).

Execution of the maneuver The osteopath is positioned with the hypothenar of

one hand on the transverse process of the dysfunctional vertebral segment, with the thenar eminence of the other hand on the opposing transverse process of the segment above or below that to be treated, placing a slight anterior pressure in order to find the motion barrier (MB) better and at the end of exhalation, without relieving the developed pressure, performing a high speed and small amplitude thrust in a forward direction in rotation with both hands (pressing in the classic butterfly motion with both hands) [6] [8] [14] (Figure 22).

Execution of the maneuver: The osteopath’s thumbs are positioned on either side of the spinal column, in contact with the paravertebral muscles overlying the transverse processes, with the fingers fanned sideways starting from the L5 transverse processes. The two thumbs exert a gentle force in the ventral direction in order to engage the soft tissue, until reaching the barrier or limit to the move- ment of the tissue moving in the cranial direction up to the dorsolumbar junction. The maneuver is repeated in a gentle, slow rhythmic manner 3 - 4 times. [6] [25] (Figure 23).

Execution of the maneuver: One of the osteopath’s hands is at the level of the dorsal-lumbar hinge, moving to find the tender side area at the level of the lateral mass of L1, or the medial tender area that lies medially with the spinous apophysis of L1. The other hand reaches for the ASIS, opposite the position of the osteopath, which is raised gently upwards to induce extension and rotation, to bring the tension towards the other hand that exerts pressure on the tender point. The pressure exerted in the tender area can be maintained for 30 seconds to 1 minute, in order to create an inhibitory function, or rhythmic pressure can be applied until changes are experienced in the tension of the tissue. The overall duration of the maneuver lasts for about two minutes [5] [6] [14] (Figure 24).

Execution of the maneuver: With the patient sitting, once the NLR point has been found with the index, middle finger or the thumb, an approximation of tissues is made before taking the reflex point well under the finger, then maintaining constant pressure by performing a rotational movement (taking care that the finger does not slip) in the entire area of the NLR, for a period of 30 - 60 seconds [6] [22] [26] (Figure 25).