Raipur is a capital city of Chhattisgarh state of India, growing rapidly in unsustainable order due to being commercial center for steel, cement and forest products. At least two million habitants are living in this city over »1.0 × 10³ km² area by discharging »3.0 × 10⁷ L/day waste water. They are dumped into seven open reservoirs constructed in the outer of city, Figure 1. The area of sewage reservoirs is ranged from 2 - 4 km². Among them, two reservoirs i.e. Urla and Siltara lie in the industrial area.

The composite water sample (100 × 5 mL from five points of each location) was collected into glass bottles (500-mL) in January 2016 as prescribed in the literature [12] . The floating algal biomass was collected manually by use of knife in a 1-L glass beaker from the waste water by subsequent washing with deionized water thrice. One kilogram of the top composite sewage sludge from five points of each location (0 - 10 cm) was taken from seven reservoirs in January 2016 by use of a stainless steel spoon and stored in a glass jar [13] . The sewage sludge and algal biomass were dried for 2 days. Thereafter, they were dried in an oven for 2 days at 50˚C to remove the moisture. The dried mass was crushed and sieved out particles of <0.25 mm for the combustion studies.

The physical parameters i.e. temperature (T), pH, electrical conductivity (EC), dissolved oxygen (DO) and reduction potential (RP) values of the water were measured at spot by Hanna made sensors. The total hardness (TH) and total alkalinity (TA) values of the filtered water were determined by the titration methods in the laboratory. The F⁻ content of water was analyzed by using the Metrohm-720 ion selective electrode in the presence of the buffer. The content of ions i.e. Cl⁻, , , , Na⁺ and K⁺ in water and sludge were analyzed by Dionex-1100 ion chromatography. A 0.25 g of the sludge sample was digested with acids (3 mL HCl and 1 mL HNO₃) in a closed system with P/T MARS CEM (Varian Company) microwave oven for use of metal analysis. The metals (i.e. Cr, Fe, Mn, Ni, Cu and Zn) in the extract were analyzed by the Varian ICP-OES-700-ES.

The bulk density (BD) was measured by the water replacement method [14] . The moisture content of the tree samples were analyzed by heating it at 105˚C ± 2˚C till constant weight is observed. The ash content of the materials was determined by heating the sample at 600˚C for 4 hr [15] . The calorific value (CV) of the sample was determined experimentally using a Digital Microprocessor Based Bomb Calorimeter UTS 1.34, Advance Research Instruments Co., New Delhi as described in the literature [16] . The calorific value was calculated by using the following equation:

where, GCV, M, We, W₁, W₂ and ∆T represent gross calorific value of species (kcal/kg), water equivalent, weight of sample, weight of cotton thread, weight of fuse wire and rise in temperature, respectively.

The content of volatile compounds including moisture was analyzed by using a Metller thermogravimetric analyzer-TGA-2 at heating rate of 20˚C/min.

The value of non-volatile (fixed) carbon (FC) was computed by subtracting the fraction (%) of moisture (MC), volatile compounds (VCs) and ash residue (AR) to the 100.

The water quality of seven sewage reservoirs of Raipur city is shown in Table 1, Table 2. The water of all reservoirs is colored with bad smell due to loading of biodegradable organics. The value of T, pH, EC, DO and RP of the water bodies (n = 7) was ranged from 28 - 33˚C, 6.6 - 9.4, 720 - 1543 µS/cm, 5.9 - 7.4 mg/L and 90 - 220 mV with mean value of 30 ± 2˚C, 7.2 ± 0.7, 1108 ± 262 µS/cm, 7.0 ± 0.4 mg/L and 137 ± 34 mV, respectively. The concentration of F⁻, Cl⁻, , , , , Na⁺, K⁺, Fe, TH and TA was ranged from 0.9 - 1.7, 48 - 84, 22 - 56, 490 - 690, 4.5 - 8.4, 7 - 13, 90 - 167, 27 - 70, 0.3 - 0.6, 240 - 360 and 340 - 720 mg/L with mean value of 1.3 ± 0.2, 62 ± 9, 41 ± 9, 606 ± 63, 6.6 ± 1.2, 10 ± 2, 136 ± 22, 46 ± 13, 0.4 ± 0.1, 299 ± 34 and 505 ± 101 mg/L, respectively. The highest value for the most of chemical parameters was seen in the water of reservoirs lie in the industrial area i.e. Urla and Siltara, Figure 2. These water bodies are bloomed with multiple algal biomass i.e. microcystis, hydrodictyon and phithophora.

All sewage sludge was colored with bad smell as shown in Table 3. The dried surface sewage sludge were found to be contaminated with nutrients i.e. P, S, Cl, K, Cr, Mn, Fe, Ni, Cu and Zn at elevated levels, ranging from 455 - 718, 941 - 1415, 328 - 471, 8474 - 10,286, 210 - 355, 1206 - 1521, 50,837 - 57,931, 57 - 113, 204 - 449 and 472 - 837 mg/kg with mean value of 570 ± 60, 1191 ± 128, 381 ± 37, 9203 ± 431, 272 ± 36, 1370 ± 81, 54,779 ± 1688, 80 ± 13, 294 ± 63 and 623 ± 93 mg/kg, respectively. The bulk density (BD), moisture content

B = Black, BrB = Brownish black, LBr = Light brown, DG = Dark grey.

(MC), calorific value (CV) and ash residue (AR) of sewage sludge of seven reservoirs were ranged from 830 - 1080 kg/m³, 2.1% - 4.6%, 1800 - 6250 kcal/kg and 41% - 49% with mean value of 949 ± 94 kg/m3, 3.2% ± 0.9%, 3999 ± 1818 kcal/kg and 44% ± 2%, respectively. Among them, the highest calorific value of sludge located in the industrial area i.e. Siltara and Urla was observed, may be due to higher nutrient loading. The CV of the sludge was correlated well (r = 0.99) with the nutrient levels and BD unlikely to the MC and AR value, Figure 3. The N, P, S, Na, K, Fe, TH and TA content of the water had fair correlation with CV of the sludge unlikely to halides i.e. F⁻ and Cl⁻, as shown in Table 4.

The combustion characteristics of four algae i.e. hydrodictyon, lyngbya, microcystis, and phithophoragrown in seven reservoirs is shown in Table 5. The value of BD, MC, CV and AR was ranged from 910 - 1070 kg/m³, 1.5% - 4.6%, 3700 - 6280 kcal/kg and 1.4% - 3.8% with mean value of 963 ± 32 kg/m³, 3.4% ± 0.6%, 4428 ± 587 kcal/kg and 2.8% ± 0.5%, respectively. The higher CV for hydrodictyon and lyngbya algae was observed, may be due to higher BD value, Figure 4. The CV of algal bloom was correlated well with BD unlikely to the MC and AR, Figure 5. The TGA chromatogram for hydrodictyon algae is shown in Figure 6. The light and heavy volatile compounds (VCs) content of the dried hydrodictyon algae was found to be 5.2% and 27.4%, respectively. The nonvolatile (fixed) carbon and ash residue content of the algae was computed and found to be 64.8%.

The CV of the dried sewage sludge and algal biomass of the studied area was found to be comparable to other regions of the World [2] - [11] .

Gr = Green, BGr = Blue green, AB = Algal bloom, MF = Mate form, SF = Scum form.