Metamaterials are unlike conventional materials, which gain their properties from their inherent composition of atoms and molecules. Metamaterial changed our perspective to this concept by replacing the molecules with manmade structures that might have dimensions of nanometers for visible light (nanorods) or in the case of GHz radiation that may be as large as a few millimeters (Split Rings Resonator SRR), but still much less than the wavelength [1]. Thus, the properties are engineered through structure rather than through chemical composition. These meta materials grasped great attention of many researchers’ worldwide, because of the peculiar characteristics and novel devices which can be built upon. Interest is focused on the propagation of electromagnetic waves in artificial materials, and particularly on materials with negative index of refraction: materials which are designed to exhibit both negative permeability and permittivity over predetermined range of frequencies [2]. In this class of materials, the electric field vector E, the magnetic field vector H, and the wave vector k form a left-hand orthogonal set [3,4], because they are called left-handed materials (LHM). A group of researchers at the University of San Diego were able to demonstrate that those materials exhibit both negative dielectric permitivity and magnetic permeability simultaneously over a certain range of frequencies [5]. It was the first time that Veselago’s prediction [6] in his pioneer paper that electromagnetic propagation in an isotropic medium with negative dielectric permittivity  and negative permeability  could exhibit unusual properties was realized. Those recent demonstrations on the existence of the LHM resulted in a wide-open to unique possibilities in the design of a novel type of device based on electromagnetic wave propagation in those materials, but in a non-conventional way. As most the communication devices include dielectric materials, which motivated us to investigate the propagation of modes in a waveguide structure made of dielectric core with thick cladding and substrate layers of left handed material (LHM), this might have a potential applications in fabricating antenna, microstrips, and couplers, since Meta materials are used in fabricating Transmission lines, Microstrip Resonators, wave division multiplexors (WDM), Couplers, Resonators, and Antennas [7-13]. This paper is organized as follows: in Section 2, we derive the TE_m modal dispersion relation in lossy LHM-Dielectric structure and the power confinement factor; Section 3 is devoted for discusses the numerical results; Section 4 is solely devoted to the conclusion.

The dispersion relation, Equation (13), numerically solved to find the complex effective wave index as a function of the angular frequency in the allowed frequency spectrum for different dielectric constants, for dielectric film thicknesses, and mode order. The power confinement factor for the structure under investigation has been investigated for the film thicknesses and mode order. The parameters of the lossy LHM have been theoretically adjusted to have negative permittivity and negative permeability in the frequency range which lies between 10.5 ~ 15.5 GHz. The parameters were used in carrying out the numerical calculations are: the plasma frequency ω_p/2π = 10.95 GHz, is the damping frequency = 0.5 GHz, and the electrons resonant frequency ω₀ = 8 GHz, and the structure factor F = 0.8. In Figure 2, we plot the real part of the effective refractive index, , for mode versus the operating frequency range at different dielectric SiO₂ core thickness. It is noticed that the real part of the effective refractive index attains small index values, which means the phase front variation upon propagation through this waveguide structure is small. Besides that, the real part of the effective refractive index decreases smoothly with frequency increase with negative slope. The negative slope indicates that the overall effect of structure behaves like left handed material (LHM), since the slope of the dispersion relation represents the group velocity [22,23]. Figure 2 also shows that, as the core’s thickness increase the real part of the effective refractive index decrease. The upper dotted curve is for a = 50 μm and the lowest solid line curve is for a = 150 μm.

In Figure 3, we plot the imaginary part of the effective refractive index (extinction coefficient), γ, for TE₀ mode versus the operating frequency range at different dielectric SiO₂ core thickness. It is noticed that the extinction coefficient attains very small negative values, which means the structure is transparent for the allowed frequency spectrum. The value of the extinction coefficient increases with core’s thickness increase. However, the extinction coefficient decreases with frequency increase.

In Figure 4, we plot the power confinement factor for TE₀ mode (Equation (17)) versus the allowed frequency range for different core’s thicknesses. Figure 4 shows that at lower frequencies the power confinement factor is better for small thickness and gets lower confinement as the core’s thickness increases. However, this behavior

flips at approximately ω = 12 GHz  and the structure guides the power better for the thicker core than the slim one. But the overall performance of the waveguide structure is good enough to be used in any possible application. This implies the structure guides the power through the core more than wasting it in the cladding, and this conclusion can also be seen from Figure 5.

In Figure 5, we plotted the power attenuation for mode (the imaginary part of Equations (17)) versus frequency for different core’s thicknesses. In Figure 5 shows that the power attenuation for mode increases with dielectric core’s thickness increase, but for each core’s thickness the power attenuation decreases with frequency increase.

In Figure 6, we explore the effect of the mode order on the real part of the effective refractive index. It is worth to notice that the real part of the effective refractive index increases with mode order increase, which means the higher the order of the mode the wave front will suffer more phase variations upon propagation in this structure. Figure 6 shows that the real part of the effective refractive index for mode (solid curve) is the lowest, and for mode (long dash curve) is highest in value. For all modes the real part of the effective refractive index decreases with operating frequency increase with negative slope, which implies that the structure behaves like left handed material (LHM) for all modes.

In Figure 7, we plot the power confinement factor versus the allowed frequency spectrum for different modes at core’s thickness a = 100 μm. Figure 7 indicated that the power confinement increases with mode order increase. Besides that the power confinement factor slightly decreases over the allowed operating frequency, and it could be considered as a constant for a given mode.

We derived the modal dispersion relation for TE_m modes for symmetric slab waveguide constructed from dielectric guiding core material with cladding and substrate made of lossy left-handed material (LHM), and the power confinement factor. The numerical solutions showed that the real part of the effective refractive index decreased with thickness and frequency increase. Moreover, the imaginary part (extinction or attenuation coefficient) of the effective refractive index has very small values for all thickness in the frequency ranges, which means the waveguide structure is transparent for the used frequencies. The waveguide structure offers good guiding for all thickness in the frequency range with low power attenuation. The real part of the effective refractive index increases with mode order increase, and the power confinement factor decreases with mode order increase. This waveguide structure is a good candidate for coupling or guiding electromagnetic waves.