TITLE:
Effect of Refining Parameters on Medium Density Fibreboard (MDF) Properties from Oil Palm Trunk
AUTHORS:
Zawawi Ibrahim, Astimar Abdul Aziz, Ridzuan Ramli, Anis Mokhtar, SiJoon Lee
KEYWORDS:
Oil Palm Trunk; Medium Density Fibreboard; Refining Pressure; Preheating Time
JOURNAL NAME:
Open Journal of Composite Materials,
Vol.3 No.4,
October
21,
2013
ABSTRACT: The properties of medium density fibreboard (MDF) made from oil palm trunk (OPT) as affected by refining pressure and preheating time were investigated. The OPT chips were refined in the MDF pilot plant by using four refining pressures (2, 4, 6 and 8 bar) and four different preheating time (100, 200, 300 and 400 seconds). The refined fibres were blended with 10% of urea formaldehyde with a board target density of 720 kg/m3. MDF boards were evaluated based on European Standard EN 622-5:2006 for thickness swelling (TS), internal bonding (IB), modulus of rupture (MOR) and modulus of elasticity (MOE). Analysis of variance (ANOVA) was used to analyze the significance of the factors. The results from this study indicated that refining pressure and preheating time are significant factors for all MDF properties. Low refining pressure and preheating time produced higher TS, lower MOR and MOE with poor bonding than those boards prepared from fibres refined at higher refining pressure and longer preheating time. OPT fibre treated with 8 bar produced good swelling resistance but detrimental on mechanical properties of the finish board. 6 bar steam pressure offered the highest value of mechanical properties (MOE, MOR and IB). Boards from intermediate refining condition (6 bar and 300 seconds) were found the better board properties having 14.58%, 0.73 N/mm2, 38 N/mm2 and 3597 N/mm2 for TS, IB, MOR and MOE respectively.