Article citationsMore>>

Y. Hasegawa, M. Shikida, D. Ogura, Y. Suzuki, and K. Sato, “Fabrication of a Wearable Fabric Tactile Sensor Produced by Artificial Hollow Fiber,” Journal of Micromechanics and Microengineering, Vol. 18, No. 8, 2008, Article ID: 085014. doi:10.1088/0960-1317/18/8/085014

has been cited by the following article:

• TITLE: Conducting Rubber Force Sensor: Transient Characteristics and Radiation Heating Effect

  AUTHORS: Masato Ohmukai, Yasushi Kami, Ken Ashida

  KEYWORDS: Conducting Rubber; Force Sensor; Electrode; Vacuum Deposition; Radiation Heating

  JOURNAL NAME: Journal of Sensor Technology, Vol.3 No.3, September 5, 2013

  ABSTRACT: Compression force sensors are indispensable to tactile sensors in humanoid robots. We are investigating the application of low-cost electrically conducting rubber sheets to force sensors, of which the biggest problem is its poor reproducibility. We have found that the deposition of aluminum by a vacuum evaporation method shows such an excellent characteristic that the sensor can be used in a wide range under 10.33 N/cm2. In this article, we investigated time response of the sensors and also studied how the radiation heating during the vacuum evaporation process for Al deposition affected their sensing property. We found that the radiation heating induces deterioration from the point of view of standard deviation of the output voltage of the sensors at a transient region. We convince that a low-temperature Al deposition method should be developed to form electrodes on the electrical conducting rubber sensors.