Article citationsMore>>

R. Amrani, D. Benlekehal, R. Baghdad, D. Senouci, A. Zeinert, K. Zellama, L. Chahed, J. D. Sib and Y. Bouizem, “Low-Temperature Growth of Nanocrystalline Silicon Films Prepared by RF Magnetron Sputtering: Structural and Optical Studies,” Journal of Non-Crystalline Solids, Vol. 354, No. 19-25, 2008, pp. 2291-2295. doi:10.1016/j.jnoncrysol.2007.10.044

has been cited by the following article:

• TITLE: Low Temperature Growth of Hydrogenated Silicon Prepared by PECVD from Argon Diluted Silane Plasma

  AUTHORS: Rachid Amrani, Pascale Abboud, Larbi Chahed, Yvan Cuminal

  KEYWORDS: Silicon; PECVD; Deposition Rate; Amorphous Nanocrystalline Transition; Argon; Low Temperature

  JOURNAL NAME: Crystal Structure Theory and Applications, Vol.1 No.3, December 31, 2012

  ABSTRACT: In order to contribute to the understanding of the optoelectronics properties of hydrogenated nanocrystalline silicon thin films, a detailed study has been conducted. The samples were deposited by 13.56 MHz PECVD (Plasma-Enhanced Chemical Vapor Deposition) of silane argon mixture. The argon dilution of silane for all samples studied was 96% by volume. The substrate temperature was fixed at 200oC. The influence of depositions parameters on optical proprieties of samples was studied by UV-Vis-NIR spectroscopy. The structural evolution was studied by Raman spectroscopy and X-ray diffraction (XRD). Intrinsic-layer samples depositions were made in this experiment in order to obtain the transition from the amorphous to crystalline phase materials. The deposition pressure varied from 400 mTorr to 1400 mTorr and the rf power from 50 to 250 W. The structural evolution studies show that beyond 200 W, we observed an amorphous-nanocrystalline transition, with an increase in crystalline fraction by increasing rf power and working pressure. Films near the amorphous to nanocrystalline transition region are grown at reasonably high deposition rates (~10 /s), which are highly desirable for the fabrication of cost effective devices. The deposition rate increases with increasing rf power and process pressure. Different crystalline fractions (21% to 95%) and crystallite size (6 - 16 nm) can be achieved by controlling the process pressure and rf power. These structural changes are well correlated to the variation of optical proprieties of the thin films.