TITLE:
Marginal discrepancy and microleakage in crown-copings fabricated by three CAD/CAM systems: An in vitro study
AUTHORS:
Marcela Herrera, Alfonso Catalán, Maritza Flores, Alejandra Martínez
KEYWORDS:
CAD/CAM Copings; Microleakage; Marginal Discrepancy; Panavia F.2
JOURNAL NAME:
Open Journal of Stomatology,
Vol.2 No.3,
September
27,
2012
ABSTRACT: The purpose of this study was to evaluate and compare the microleakage and marginal discrepancy of ceramic crown-copings fabricated by three different CAD/CAM systems. Material and methods: Thirty extracted premolars were prepared for complete all-ceramic crowns with: total convergence 10-degree, 2 mm occlusal reduction, 4.5 mm height, 1.3 mm circular reduction and chamfer marginal preparation. They were divided into three groups and each group (n = 10) received a ceramic crown-coping fabricated by one of three CAD/CAM systems: Procera, KaVo Everest and Cerec inLab. The copings were cemented with Panavia F 2.0. After thermal cycling, the teeth were immersed in 2% basic fuchsine dye for 24 hours. Microleakage was scored using a five-point scale and evaluated under a stereomicroscope at ×18. Marginal discrepancies were assessed with scanning electronic microscope at ×150, with measurements at 50 different points. Data were subjected to a chisquare test, Kolmogorov-Smirnov test and using Rho Spearman’s correlation test (P 0.05). No significant differences were found in marginal discrepancies for the Procera (62.58 ± 8.98 μm) and KaVo Everest systems (65.54 ± 18.56 μm), (P = 0.941). Significant differences were found for Cerec inLab (132.18 ± 27.75 μm) compared with Procera and KaVo Everest (P = 0.0001). No correlation between the marginal discrepancies and microleakage for the three CAD/CAM crown-copings systems. Conclusions: Cerec inLab CAD/CAM crown-copings showed significantly higher values for microleakage and marginal discrepancy in comparison with Procera and KaVo Everest CAD/CAM crown-copings.