Article citationsMore>>

He, W., Zhang, Y.F., Lee, K.S., Lu, L., Xie, S.S. and Jin, Q.J., “Microstructure and mechanical properties of an Al/SiCp, composite cold die forged gear.” Materials & Design.17(2), (1996),pp. 97-102.

has been cited by the following article:

• TITLE: Forgeability and Machinability of Stir Cast Aluminum Alloy Metal Matrix Composites

  AUTHORS: Rabindra Behera, S. Das, D. Chatterjee, G. Sutradhar

  KEYWORDS: MMC, Mechanical properties, Forgeability, Machining, Surface roughness

  JOURNAL NAME: Journal of Minerals and Materials Characterization and Engineering, Vol.10 No.10, August 10, 2011

  ABSTRACT: In the present paper, the aluminum alloy i.e. LM6 based composites reinforced with different weight fraction of SiC particles was produced by stir cast technique and the effect of reinforced ratios on the forgeability and the machinability was examined. The test results show that the increment in weight fraction of reinforcement particles in the matrix metal produced better mechanical property like hardness but the forgeability of the cast MMCs decreases. The forgeability of the as cast MMCs were also varied with the change in thickness of the casting. The results show that the forgeability of cast metal matrix composites at the mid section of the casting is minimum compared to both end section of a three-step casting. The effect of machining parameters, e.g. cutting speed and depth of cut on the surface roughness and cutting forces at constant feed rate was investigated during experimentation. The results show that higher weight percentage of SiCp reinforcement produced a higher surface roughness and needs higher cutting forces during machining operation. It has also observed that the depth of cut and the cutting speed at constant feed rate affected the surface roughness and the cutting forces. This practical research analysis and test results on the forgeability and machinability of Al/SiC-MMC will provide useful guidelines to the present day manufacturing engineers.