TITLE:
Geotechnical Characterisation and Rainfall-Sensitive Stability of a Residual Elastic-Silt Slope over Weathered Jurassic Shale at Miritini, Mombasa, Kenya
AUTHORS:
Charles Ngala Kithome, Clifford Arum Obara
KEYWORDS:
Slope Stability, Residual Soil, Elastic Silt, Weathered Shale, Infinite Slope, Pore-Water Pressure, Point Load Test, Standard Penetration Test, RTK-GNSS Survey, Miritini, Mombasa
JOURNAL NAME:
Journal of Geoscience and Environment Protection,
Vol.14 No.11,
November
20,
2026
ABSTRACT: Cut and natural slopes on the Jurassic foot plateau west of Mombasa carry pipelines, storage depots and the Standard Gauge Railway, yet the residual soils that mantle them are rarely characterised for stability. This paper presents a geotechnical characterisation of a slope at Miritini, Mombasa County, investigated for a slope-monitoring programme with eight rotary-cored boreholes to 20 m (160 m in total), Standard Penetration Tests, laboratory classification, compaction and shear-box tests, and 32 point-load tests on rock core. The ground comprises 2.5 - 11.5 m of reddish-brown to grey sandy elastic silt (MH; predominantly A-7-5) with local silty sand, over completely to highly weathered, fractured shale that becomes moderately weathered at depth. The silt has liquid limits of 51% - 74%, plasticity indices of 17% - 32% and 29% - 45% clay, with shear-box parameters of c' = 12 - 18 kPa and φ' = 15˚ - 19˚, treated as indicative because the test procedure was not recorded. The shale is a weak rock, with equivalent uniaxial compressive strengths of 5.2 - 8.5 MPa that increase with depth. Groundwater was struck at 0.4 - 11.0 m during water-flush drilling, and ponding was observed near the crest. Hand-held GPS elevations define a 13˚ - 16˚ scarp that falls 37 - 44 m from a 54 - 64 m plateau; an RTK-GNSS survey confirms the analysed gradients (12.6˚ - 15.6˚) and maps ten slope failures, covering 4.9% of the plot, across the scarp, where local faces reach 20˚ - 23˚. Infinite-slope analyses, with the water-table ratio treated as a parametric variable, show that the cohesive cases have FS above unity under the modelled zero-positive-pore-pressure condition (1.5 - 2.1 at 5 m depth) but approach or fall below unity at a representative 11 m soil-rock contact when the water-table ratio exceeds 0.34 - 0.82, depending on slope angle and strength parameters; loss of cohesion and steeper local gradients can also reduce FS below unity. A saturated mantle would need 32 - 42 kPa of cohesion, over twice the measured value, for FS = 1.3 at that contact. Stability is therefore controlled by pore pressure rather than by soil strength alone. Piezometric and inclinometer monitoring, crest drainage and testing of undisturbed and residual strength are recommended.