Article citationsMore>>

E. Baudrez, G. J. Heynderickx and G. B. Marin, “Steadystate Simulation of Fluid Catalytic Cracking Riser Reactors Using a Decoupled Solution Method with Feedback of the Cracking Reactions on the Flow,” Chemical Engineering Research and Design, Vol. 88, No. 3, 2010, pp. 290-303. doi:10.1016/j.cherd.2009.05.003

has been cited by the following article:

• TITLE: Parametric Sensitivity Studies in a Commercial FCC Unit

  AUTHORS: Prabha K Dasila, Indranil Choudhury, Deoki Saraf, Sawaran Chopra, Ajay Dalai

  KEYWORDS: Fluid Catalytic Cracking; Parametric Sensitivity Analysis; Kinetic Modeling of FCC Riser/Reactor; Regenerator Modeling

  JOURNAL NAME: Advances in Chemical Engineering and Science, Vol.2 No.1, December 31, 2011

  ABSTRACT: A steady state model was developed for simulating the performance of an industrial fluid catalytic cracking (FCC) unit which was subsequently used in parametric sensitivity studies. The simulator includes kinetic models for the riser reactor and the regeneration systems. Mass and energy balances were performed for each of these sections and simulation results were compared with the plant data available in the literature. Model predictions were found to be in close agreement with the reported data. Finally this validated model was used for studying the effects of independent variables such as feed preheat temperature (Tfeed) and feed flow rate (Ffeed) on the unit performance at either fixed regenerated catalyst temp/regenerator temp (Trgn) or constant reactor outlet temperature (ROT). The catalyst circulation rate (CCR) was automatically adjusted to keep the ROT constant with varying the independent variables feed preheat temperature while the air rate adjusted for keeping the regenerator temperature constant which consequences the dependency of both dependent and independent variables on the unit performance. The air flow rate to the regenerator was also an independent variable during the parametric sensitivity analysis and its effect on FCC performance was investigated at constant Tfeed, Ffeed and CCR. Combining all the sensitivity analysis, it has been found to increase gas oil conversion and product yields by 5 to 6 percent with decrease of say, 10 K, in the feed preheat temperature (Tfeed) and corresponding increase in air rate (Fair) and catalyst circulation rate (Frgc) at constant reactor outlet temperature (ROT) and regenerated catalyst temperature (Trgc).