TITLE:
Static and Thermal Analysis of Aluminium (413,390,384 and 332) Piston Using Finite Element Method
AUTHORS:
Offei David Inusah, Jacob Kwaku Nkrumah, Vincent Akolbire Atindana
KEYWORDS:
Von Mise stress, Total deformation, Aluminium alloy, Thermal analysis., Piston, Static structural, Heat fux
JOURNAL NAME:
Modeling and Numerical Simulation of Material Science,
Vol.14 No.1,
November
28,
2023
ABSTRACT: The main objective of this research was to examine the suitability of aluminium alloy to design a piston of an internal combustion engine for improvement in weight and cost reduction. The piston was modelled using Autodesk Inventor 2017 software. The modelled piston was then imported into Ansys for further analysis. Static structural and thermal analysis were carried out on the pistons of the four different materials namely: Al 413 alloy, Al 384 alloy, Al 390 alloy and Al332 alloy to determine the total deformation, equivalent Von Mises stress, maximum shear stress, and the safety factor. The results of the study revealed that, aluminium 332 alloy piston deformed less compared to the deformations of aluminium 390 alloy piston, aluminium 384 alloy piston and aluminium 413 alloy piston. The induced Von Mises stresses in the pistons of the four different materials were found to be far lower than the yield strengths of all the materials. Hence, all the selected materials including the implementing material have equal properties to withstand the maximum gas load. All the selected materials were observed to have high thermal conductivity enough to be able to withstand the operating temperature in the engine cylinders.