Article citationsMore>>

Patel, J.B., Cockerill, F. R., Bradford, P.A., Eliopoulos, G.M., Hindler, J.A., Jenkins, S.G., Lewis, J.S., Limbago, B., Miller, L.A., Nicolau, D.P., Powell, M., Swenson, J.M., Traczewski, M.M., Turnidge, J.D., Weinstein, M.P. and Zimmer, B.L. (2015) Performance Standards for Antimicrobial Susceptibility Testing; Twenty-Fifth Informational Supplement (M100-S25). Clinical and Laboratory Standard Institute, Wayne, Pennsylvania, 132-135.

has been cited by the following article:

• TITLE: Optimized Biosurfactant Production by Pseudomonas aeruginosa Strain CGA1 Using Agro-Industrial Waste as Sole Carbon Source

  AUTHORS: Chikodili G. Anaukwu, Chioma M. Ogbukagu, Ikechukwu A. Ekwealor

  KEYWORDS: Pseudomonas aeruginosa, Optimization, Response Surface Methodology, Biosurfactant, Sugar Cane Molasses, Lipopeptide

  JOURNAL NAME: Advances in Microbiology, Vol.10 No.10, October 28, 2020

  ABSTRACT: Biosurfactants are biomolecules produced by microorganisms, which possess several advantages over their chemical counterparts. Production can be cost-effective if renewable wastes are utilized as substrates. In this study, optimization of biosurfactant production by Pseudomonas aeruginosa strain CGA1 was carried out using response surface methodology. The conventional “One factor at a time” method of optimization was initially adopted to ascertain the impact of different renewable wastes on biosurfactant production. Four independent variables were tested: carbon and nitrogen concentration, medium volume, and inoculum size. Biosurfactant production was based on the emulsification index measurement. Results indicated that the preferred carbon source by the isolate was sugar cane molasses. A 2.31-fold increase in biosurfactant yield and emulsification index of 96.3% ± 0.75% under optimized cultural conditions of 20 g/L of molasses, 5 g/L of sodium nitrate, 1.93 ml inoculum size and 60 ml medium volume in 250 ml conical flask were obtained. The regression coefficient (R2) value of 84.15% implied adequate fitness of the model. The surface tension of distilled water was reduced from 72.1 mN/m to 35.0 ± 0.0 mN/m, and critical micelle concentration was attained at 60 mg·L-1. FTIR and GC-MS analysis indicated that the biosurfactant was a lipopeptide having characteristic lipid and peptide peak values. This study proves that the sole use of agro-industrial wastes for the production of biosurfactant is very efficient, and ensures the economic feasibility of biosurfactant production.