TITLE:
Geopolymer Mortar with the Tailings from the Fundão Dam Rupture
AUTHORS:
Glaucia Marcossi Cardoso Duarte, Fabiana Grasiele Penido Andrade Silva, Fernando Soares Lameiras, Ana Maria Matildes dos Santos
KEYWORDS:
Geopolymer, Candonga Tailings, Mortar
JOURNAL NAME:
Technology and Investment,
Vol.11 No.4,
September
2,
2020
ABSTRACT: The extraction of iron ore generates large amounts of tailings. In addition to other solutions to avoid storing this material in dams, it is important to use these tailings as raw materials for the manufacturing of consumer goods. One possible solution is to use geopolymer cement in mortars for civil construction with employment of the tailings as substitute for usual sands. Geopolymers are produced from alkaline activation of aluminosilicates. They can incorporate a larger amount of tailings than the Portland cement. The tailings from the rupture of the Fundão dam, which were retained in the water reservoir of the Candonga hydropower plant were characterized as a fine aggregate for civil construction and used to obtain geopolymer mortar. Metakaolin was mixed with an alkaline solution of sodium silicate and sodium hydroxide to form a paste. The tailings were added and uniformly mixed to this paste. Two series of experiments were conducted with addition of 40 and 60 wt% of tailings to the geopolymer paste. The fresh mortars were placed in cylindrical molds. The samples were left to harden at room temperature or at 60°C for 24 hours and demolded. After hardening, the samples were cured at room temperature for 7 and 28 days. The samples were characterized by their compressive strength, water absorption, and density. The results were analyzed according to a 23 factorial design with the factors: composition (amount of tailings added to the mortar), hardening conditions, and curing time. For all responses (compressive strength, water absorption, and density), the results show a complex behavior with influence of the factors and their interactions. Compressive strengths from 19 to 43 MPa, water absorptions from 19 to 41 wt%, and densities from 1.60 to 2.11 g/cm3 were observed. These properties can be controlled by adjusting the levels of the factors according to empirical models. This mortar can be considered for applications in civil construction.