Article citationsMore>>

Keerthiprasad, K.S., Murali, M.S., Mukunda, P.G. and Majumdar, S. (2011) Numerical Simulation and Cold Modeling Experiments on Centrifugal Casting. Metallurgical and Materials Transactions B, 42, 144-155.
https://doi.org/10.1007/s11663-010-9402-4

has been cited by the following article:

• TITLE: Analysis of Molten Metal Distribution in the Mold of a Horizontal Centrifugal Casting

  AUTHORS: Miguel A. Barron, Dulce Y. Medina, Joan Reyes

  KEYWORDS: Angular Velocity, Centrifugal Casting, Computational Fluid Dynamics, Molten Metal, Viscosity, Wall Roughness

  JOURNAL NAME: Open Journal of Applied Sciences, Vol.10 No.7, July 17, 2020

  ABSTRACT: It is numerically studied the influence of the angular velocity, the molten metal viscosity, and the mold wall roughness on the molten metal distribution in the mold of a horizontal centrifugal casting process. The undesirable raining phenomenon sometimes arises in horizontal centrifugal casting. It occurs when the molten metal rains or falls from the top of the mold to the bottom while the mold is rotating. Using Computational Fluid Dynamics simulations, the conditions for the emergence of the raining phenomenon were explored in this work. For the system considered, angular velocities less than 77 rad/s cause the emergence of the raining phenomenon and accumulation of the molten metal in the lower part of the mold, whereas angular velocities greater than 77 rad/s produce a constant thickness of the molten metal and prevent raining.