Article citationsMore>>

Cocks, G., Keeley, R., Leek, C., Foley, P., Bond, T., Crey, A., Paige-Green, P., Emery, S., Clayton, R., Iness and Les Marchant, M.D. (2015) The Use of Naturally Occurring Materials for Pavements in Western Australia. Australian Geomechanics, 50, 43-106.

has been cited by the following article:

• TITLE: Improvement of the Geotechnical Properties of the Soil of Lime-Treated Cubitermes Mound Soil

  AUTHORS: Séverin Jean Maixent Loubouth, Louis Ahouet, Raymond Gentil Elenga, Sylvain Ndinga Okina, Paul Louzolo Kimbembe

  KEYWORDS: Cubitermes Mound Soil, CEBTP 1980, Unpaved Roads, Geotechnical Properties

  JOURNAL NAME: Open Journal of Civil Engineering, Vol.10 No.1, January 31, 2020

  ABSTRACT: This work consisted in determining the geotechnical properties of the soil of the Cubitermes termite mound soil treated with lime for use in road construction in accordance with the relevant standards. The raw soil is composed of 29.45% clay, 45.12% silt and 25.43% sand, and its granulometric curve is above the relevant standard curve. The addition of lime up to 9% decreases the fine fraction content from 75% to 60%, and the maximum dry density from 1.62 t/m3 to 1.36 t/m3. The reduction of the fine fraction should reduce the soil sensitivity to water, and the emission of dust from the road. The compressive strength of the raw soil (3.89 MPa) is higher than that of most cohesive soil, and is probably one the causes of the longevity of the rural road paved with this soil. Treated soil with 6% in lime content has the highest compressive strength (5.95 MPa), and the lowest deformation at failure. Until 28 days, the improvement of the compressive upon the curing time is almost the same for untreated and treated termite mound soils. Thus, this improvement could be mostly attributed to the drying of the samples instead to the pozzolanic reactions. Besides, adding lime also enhances the shear strength of soil. Therefore, adding lime up to 6% in content to the termite mound soil should improve its behavior as surface roads.