TITLE:
Waste Biomass Gasification Simulation Using Aspen Plus: Performance Evaluation of Wood Chips, Sawdust and Mixed Paper Wastes
AUTHORS:
Sahar Safarian, Christiaan Richter, Runar Unnthorsson
KEYWORDS:
Waste Biomass Gasification, Simulation Model, Gasifier Performance, Waste to Energy
JOURNAL NAME:
Journal of Power and Energy Engineering,
Vol.7 No.6,
June
26,
2019
ABSTRACT: Biomass is one of the most widely available energy sources and gasification is a thermal conversion process where biomass is transformed into a fuel gas with a gasifying agent. In this paper by using ASPEN Plus, a new steady state simulation model for down draft waste biomass gasification was developed. The model that is stoichiometric equilibrium-based is proposed to be used for optimization of the gasifier performance. Prediction accuracy of the model is validated by comparing with available experimental and modeling results in other literature. Then the model is used for comparative analysis of the gasification performance of sawdust, wood chips and mixed paper wastes. In the model, the operating parameters of temperature and equivalence ratio (ER) have been varied over wide range and their effect on syngas composition, syngas yield, low heating value (LHV) of syngas and cold gas efficiency (CGE) has been investigated. Raise in temperature increases the production of CO and H2 which leads to higher syngas yield, LHV and CGE. However, increasing ER decreases the production of CO and H2 which results lessens in LHV and CGE but syngas yield continuously increases because more oxygen is available for biomass reactions at high ER. The optimal values of CO and H2 mole fraction and CGE of sawdust, wood chips and mixed paper wastes are located at 900°C, 1000°C and 1000°C, respectively and ER range is between 0.20 - 0.35 regardless of the kind of biomass which is used as the feedstock.