Article citationsMore>>

M.-G. Kang, “Effect of Surface Roughness on Pool Boiling Heat Transfer,” International Journal of Heat Mass Transfer, Vol. 43, No. 22, 2000. pp. 4073-4085. doi:10.1016/S0017-9310(00)00043-0

has been cited by the following article:

• TITLE: Concerning The Effect of Surface Material on Nucleate Boiling Heat Transfer of R-113

  AUTHORS: Reza Hosseini, Amir Gholaminejad, Mahdi Nabil

  KEYWORDS: Boiling Heat Transfer, R-113, Nucleate Boiling, Surface Material

  JOURNAL NAME: Journal of Electronics Cooling and Thermal Control, Vol.1 No.2, September 30, 2011

  ABSTRACT: This paper presents results of an experimental investigation carried out to determine the effects of surface material on nucleate pool boiling heat transfer of refrigerant R113. Experiments were performed on horizontal circular plates of brass, copper and aluminum. The heat transfer coefficient was evaluated by measuring wall superheat and effective heat flux removed by boiling. The experiments were carried out in the heat flux range of 8 to 200 kW/m2. The obtained results have shown significant effect of surface material, with copper providing the highest heat transfer coefficient among the samples, and aluminum the least. There was negligible difference at low heat fluxes, but copper showed 23% better performance at high heat fluxes than aluminum and 18% better than brass.