TITLE:
Irrigation Termination Thermal Time and Amount on Cotton Lint Yield and Fiber Quality
AUTHORS:
Robert J. Lascano, R. Louis Baumhardt, Timothy S. Goebel, Jeffrey T. Baker, Dennis C. Gitz III
KEYWORDS:
Irrigation Scheduling, Semiarid, Limited Water, Texas High Plains, Evapotranspiration
JOURNAL NAME:
Open Journal of Soil Science,
Vol.7 No.9,
September
13,
2017
ABSTRACT: Cotton irrigation in the Texas High Plains (THP) is often dictated by the well capacity and not by the water needs of the crop. The source of irrigation-water is the Ogallala aquifer and in many areas of the THP, the water table has declined to well capacities that deliver 1.3 to >7.6 mm/d. There is plenty of information on cotton responses to irrigation frequency and amount; however, information on when to terminate irrigation and its effect on cotton lint yield and fiber quality is scarce. Our objective was to evaluate over a 4-year period three irrigation termination thermal times corresponding to cumulative daily heat units (∑HU) of 890 °C, 1000 °C and 1110 °C from crop emergence, and three levels of irrigation (2.5, 5.1 and 7.6 mm/d) on cotton lint yield and fiber quality. Irrigation was applied with a sprinkler system on a 3-day frequency in Lubbock, TX. Results showed that on average the 7.6 mm/d level produced the most cotton lint yield regardless of the irrigation termination thermal time. Terminating cotton at 1000- °C ∑HU resulted in water savings of 25 to 50 mm for the 2.5 and 5.1 mm/d levels without significantly affecting lint yield. For the 7.6 mm/d and terminating at 890- °C ∑HU resulted in water savings of 100 to 115 mm. Average fiber length statistically increased with termination thermal time and level. This effect was most significant in years with the least rain and warmer air temperature. Micronaire increased with the termination thermal time in years with >500 mm of rain. Average fiber length uniformity and fiber strength were minimally affected by termination thermal time. As irrigation level increased, the average micronaire decreased, and fiber strength increased for the 5.1 and 7.6 mm/d irrigation. We concluded that in the THP for well capacities that deliver 2.5 - 5.1 mm/d irrigation can be terminated when the ∑HU reaches about 1000 °C from emergence without impacting cotton lint yield.