Article citationsMore>>

Leong, Y.W., Yamaguchi, S., Mizoguchi, M., Hamada, H., Ishiaku, U.S. and Tsujii, T. (2004) The Effect of Molding Conditions on Mechanical and Morphological Properties at the Interface of Film Insert Injection Molded Polypropylene-Film/Polypropylene Matrix. Polymer Engineering and Science, 44, 2327-2334.
https://doi.org/10.1002/pen.20260

has been cited by the following article:

• TITLE: Withdraw: Improvement on Adhesion Properties of Insert Injection Molding Composites: Effect of Inserted Parts, Adhesive Lengths and Injection Conditions

  AUTHORS: Badin Pinpathomrat, Hiroyuki Hamada

  KEYWORDS: Insert-Injection Molding, Adhesive Length, Adhesive Normal/Shear Load, Injection Molding Condition, Polypropylene Glass Fiber Composite

  JOURNAL NAME: Open Journal of Composite Materials, Vol.7 No.4, July 27, 2017

  ABSTRACT: Short Retraction Notice The paper does not meet the standards of "Open Journal of Composite Materials". This article has been retracted to straighten the academic record. In making this decision the Editorial Board follows COPE's Retraction Guidelines. The aim is to promote the circulation of scientific research by offering an ideal research publication platform with due consideration of internationally accepted standards on publication ethics. The Editorial Board would like to extend its sincere apologies for any inconvenience this retraction may have caused. Editor guiding this retraction: Prof. Chengye Fan (EiC of OJCM) The full retraction notice in PDF is preceding the original paper, which is marked "Withdraw".