Article citationsMore>>

Dlubek, G., Krause, S., Krause, H., Berasina, A.L., Mikhalenkav, V.S. and Chuistov, K.V. (1992) Positron Studies of Precipitation Phenomena in Al-Li and in Al-LI-X (X=Cu, Mg or Sc) Alloys. Journal of physics: Condensed Matter, 4, 6317-6328.
http://dx.doi.org/10.1088/0953-8984/4/29/015

has been cited by the following article:

• TITLE: Experimental Investigation of the Early Stage of Precipitation on Binary Al-Li, Al-Cu Alloys and Ternary Al-Li-Cu Alloys by Means of Atom Probe Tomography

  AUTHORS: Muna Khushaim, Torben Boll

  KEYWORDS: Phase Decomposition, Atom Probe Tomography, Early Stage of Precipitation

  JOURNAL NAME: Open Journal of Metal, Vol.6 No.2, June 30, 2016

  ABSTRACT: Aluminum-based alloys play a key role in modern engineering and are widely used in construction components in aircraft, automobiles and other means of transportation due to their light weight and superior mechanical properties. Introduction of different nano-structure features can improve the service and the physical properties of such alloys. An improvement of an Al-based alloy has been performed based on the understanding of the relationships among compositions, processing, microstructural characteristics and properties. Knowledge of the decomposition process of the microstructure during the precipitation reaction is particularly important for future technical developments. The objective of this study is to investigate the nano-scale chemical composition in the Al-Cu, Al-Li and Al-Li-Cu alloys during the early stage of the precipitation sequence and to describe whether this compositional difference correlates with variations in the observed precipitation kinetics. Investigation of the fine scale segregation effects of dilute solutes in aluminum alloys which were experienced different heat treatments by using atom probe tomography has been achieved. The results show that an Al-1.7 at.% Cu alloy requires a long ageing time of approximately 8 h at 160°C to allow the diffusion of Cu atoms into Al matrix. For the Al-8.2 at.% Li alloy, a combination of both the natural ageing condition (48 h at room temperature) and a short artificial ageing condition (5 min at 160°C) induces increasing on the number density of the Li clusters and hence increase number of precipitated particles. Applying this combination of natural ageing and short artificial ageing conditions onto the ternary Al-4 at.% Li-1.7 at.% Cu alloy induces the formation of a Cu-rich phase. Increasing the Li content in the ternary alloy up to 8 at.% and increasing the ageing time to 30 min resulted in the precipitation processes ending with δ' particles. Thus the results contribute to the understanding of Al-alloy design.