Article citationsMore>>

Kovaleva, M., Tyurin, Y., Vasilik, N., Kolisnichenko, O., Prozorova, M., Arseenko, M., Yapryntsev, M., Sirota, V. and Pavlenko, I. (2015) Effect of Processing Parameters on the Microstructure and Properties of WC-10Co-4Cr Coatings Formed by a New Multi-Chamber Gas-Dynamic Accelerator. Ceramics International, 41, 15067-15074.
http://dx.doi.org/10.1016/j.ceramint.2015.07.169

has been cited by the following article:

• TITLE: Tribological Behavior of Thermally Sprayed WC Coatings under Water Lubrication

  AUTHORS: Chaoqun Zhang, Masahiro Fujii

  KEYWORDS: Thermally Spraying, WC Coatings, Water Lubrication, Friction, Wear

  JOURNAL NAME: Materials Sciences and Applications, Vol.7 No.9, September 16, 2016

  ABSTRACT: Thermally sprayed coatings have been used in various fields of industry for enhancing surface characteristics of materials and extending their service life. The contact surface of some mechanical equipment such as the fine pulverization equipment which is used in the woody biomass production process is required to have wear resistance in the water environment. Thermally sprayed coatings would be a good candidate to improve surface wear resistance under water lubrication. The objective of this study was to evaluate the tribological performance of thermally sprayed coatings under water lubrication. Thermally sprayed coatings which were classified into WC, WB and Ni spraying of three categories were compared with water-lubricated sliding test at a sliding velocity of 0.02 m/s and mean pressure of p0 = 10 MPa with a ring-on-disk apparatus. Thermally sprayed coatings showed comparatively high friction coefficient and well wear resistance under water lubrication. WC contained coatings showed better wear resistance than WB and Ni coatings. Thermally sprayed coatings showed obviously different mechanical properties and tribological behaviors, and the effect of wettability and hardness on tribological characteristics was discussed under water lubrication. Friction coefficient increased as the surface contact angle of thermally sprayed coatings increased. The wear rate decreased as the surface hardness of thermally sprayed coatings increased. Wear resistance of thermally sprayed coatings was excellent under water lubrication. WC contained coatings showed lower wear rate than WB and Ni coatings. WC-14CoCr coating showed the lowest wear rate.