Article citationsMore>>

E. M. Ruiz-Navas, J. B. Fogagnolo, F. Velasco and L. Froyn, “One Step Production of Aluminum Matrix Composite Powder by Mechanical Alloying,” Composites Part A: Applied Science and Manufacturing, Vol. 37, No. 11, 2006, pp. 2114-2120. http://dx.doi.org/10.1016/j.compositesa.2005.11.016

has been cited by the following article:

• TITLE: Effect of Alumina Particles Addition on Physico-Mechanical Properties of AL-Matrix Composites

  AUTHORS: Moustafa M. M. Mohammed, Omayma A. Elkady, Abdelhameed Wazeer Abdelhameed

  KEYWORDS: Al matrix Composites; Alumina Reinforcement; Mechanical Mixing; Thermal Conductivity; Electrical Conductivity; Mechanical Properties

  JOURNAL NAME: Open Journal of Metal, Vol.3 No.4, December 13, 2013

  ABSTRACT: Metal-matrix composites (MMCs) are attracting considerable interest worldwide because of their superior mechanical and tribological properties. This study describes multifactor-based experiments that were applied to research and investigates Aluminum matrix composite reinforced with 5, 10 & 15 wt% Alumina particles. Mechanical mixing technique was used for fabrication. Sintering was carried out in a vacuum furnace at 600°C for 1 hr. The effects of Alumina percentage on the density, microstructure, both electrical & thermal conductivities, hardness and compression strength was investigated. The results showed that sample containing 5 wt% Alumina is near-fully dense. Also it has the highest hardness and compression strength.